
LPC3250 Developer’s Kit v2 - User’s Guide
Copyright 2012 © Embedded Artists AB
Connects to MCIDAT1 on SD/MMC connector
Connects to MCIDAT2 on SD/MMC connector
Connects to MCIDAT3 on SD/MMC connector
No special usage on OEM Base Board, but is used for
SPI_SSEL on the boot serial flash on the LPC3250 OEM
board
Connects to LCD expansion connector (backlight control).
Connects to USB1-up LED (active low).
Connects to serial expansion connector.
Connects to RS422/485 transmit/receive control.
Can optionally be connected to USB1 VBUS power enable.
Note that the LPC3250 cannot control these functionalities
on the OEM base board since GPIO43 is connected to an
input (GPI_03) on the LPC3250.
LCD databit 12
Can optionally be connected to USB1 VBUS feedback.
LCD databit 21.
Also connected to USB OTG transceiver, interrupt signal.
Can optionally be connected to USB1 VBUS power switch
over-current flag (not used on the LPC3250).
LCD databit 22.
Can also be connected to USB OTG transceiver(not used
on the LPC3250)
LCD databit 23.
Can also be connected to USB OTG transceiver (not used
on the LPC3250)
Connects to USB2 VBUS signal.
Connects to USB2 VBUS power switch over-current flag.
Can be connected to I2S audio codec BCKI (I2STX-BCK)
Can be connected to I2S audio codec BCKI (I2STX-DATA)
Can be connected to I2S audio codec BCKI (I2STX-WS)
Can be connected to I2S audio codec BCKI (I2SRX-BCK)
Comentarios a estos manuales